Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 93)

–93–

Section 27. SPECIFICATIONS &

ACCESSORIES

Specifications

AM100

SECURITY

CONTROL

1. Physical: 12-1/2" W x 14-1/2" H x 3" D (318mm x 368mm x 76mm)

2. Electrical:

VOLTAGE INPUT: 16.5VAC from plug-in 25VA transformer, Ademco No.

1321 (in U.S.A.)

RECHARGEABLE BACK-UP BATTERY: 12VDC, 4AH (Gel type).

Charging Voltage: 13.8VDC.

ALARM SOUNDER: 12V, 2.0 Amp output can drive 12V BELLS or can

drive one or two 702 (series connected) self-contained 20-watt sirens. Do

not connect two 702s in parallel.

AUXILIARY POWER OUTPUT: 12VDC, 600mA max. Interrupts for 4-

wire smoke detector reset.

Note: For UL installations, Alarm Sounder plus Auxiliary Power

currents should not exceed 700mA total.

STANDBY TIME: (see Table in POWERING THE SYSTEM section)

FUSE: Battery (3A) No. 90–12

3. Communication:

FORMATS SUPPORTED:

Ademco Express,

10 characters/sec, DTMF (TouchTone) Data Tones, 1400/2300Hz ACK,

1400Hz KISSOFF.

Ademco Contact ID Reporting,

10 characters/sec., DTMF (TouchTone) Data Tones, 1400/2300Hz ACK,

1400Hz KISSOFF.

Ademco Low Speed, 10 pulses/sec, 1900Hz Data Tone,

1400Hz ACK/KISSOFF.

Radionics/SESCOA, 20 pulses/sec, 1800Hz Data Tone, 2300Hz

ACK/KISSOFF. Can report 0–9, B–F

Line Seize: Double Pole

Ringer Equivalence: 0.7B

FCC Registration No.: AC 398U–68192–AL–E

4. Maximum Zone Resistance: Zones 1–8 = 300 ohms excluding EOLR

AM6128

REMOTE KEYPAD

1. Physical: 5-3/4" W x 4-3/4" H x 1" D (146mm x 121mm x 26mm)

2. Electrical: Voltage Input: 12VDC; Current Drain: 30mA

3. Interface Wiring: To control panel’s keypad connection points as follows:

RED: 12VDC input (+) aux pwr

GREEN: Data Out to Control

YELLOW: Data In from Control

BLACK: Ground

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 93

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56