Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 49)

–49–

Section 15.

ZONE RESPONSE TYPE DEFINITIONS

General Information

You must assign a zone type to each zone, which defines the way in which the

system responds to faults in that zone. Zone types are defined below.

Type 00

Zone Not Used

Program a zone with this zone type if the zone is not used.

Type 02

Entry/Exit Burglary #22

This zone type provides a secondary entry delay whenever the zone is faulted

if the panel is armed in the AWAY and HOME modes. When the panel is

armed in the INSTANT or MAXIMUM modes, no entry delay is provided.

Entry delay #2 is programmable from 0 - 99 seconds.

The programmed exit delay (field *34) begins whenever the control is armed,

regardless of the arming mode selected.

This zone type is usually assigned to sensors or contacts on doors through

which secondary entry and exit will take place, and where more time might

be needed to get to and from the keypad (typically used for a garage, loading

dock, or basement door).

Type 03

Perimeter Burglary

This zone type gives an instant alarm if the zone is faulted when the panel is

armed in the AWAY, HOME, INSTANT or MAXIMUM modes. This zone

type is usually assigned to all sensors or contacts on exterior doors and

windows.

Type 04

Interior, Follower

This zone type gives a delayed alarm (using the programmed Entry/Exit

time) if the Entry/Exit zone is faulted first. Otherwise this zone type gives an

instant alarm. This zone type is active when the panel is armed in the

AWAY and MAXIMUM modes. This zone type is bypassed

automatically when the panel is armed in the HOME or INSTANT

modes. This zone type is usually assigned to a zone covering an area such as

a foyer, lobby, or hallway through which one must pass upon entry (After

faulting the entry/exit zone to reach the keypad to disarm the system).

Since this zone type is designed to provide an instant alarm if the entry/exit

zone is not violated first, it will protect an area in the event an intruder hides

on the premises prior to the system being armed, or gains access to the

premises through an unprotected area.

Type 05

Trouble by Day/

Alarm by Night

This zone type will give an instant alarm if faulted when armed in the

AWAY, HOME, INSTANT or MAXIMUM (night) modes. During the

disarmed state (day), the system will provide a latched trouble sounding from

the keypad (and a central station report, if desired). This zone type is usually

assigned to a zone which contains a foil-protected door or window (such as in

a store), or to a zone covering a "sensitive" area such as a stock room, drug

supply room, etc. This zone type can also be used on a sensor or contact in an

area where immediate notification of an entry is desired.

Type 01

Entry/Exit Burglary #11

This zone type provides exit and entry delays whenever the zone is faulted if

the control is armed in the AWAY or HOME modes. When the panel is armed

in the INSTANT or MAXIMUM modes, no entry delay is provided. Entry

delay #1 is programmable from 0 - 99 seconds.

Exit delay begins whenever the control is armed, regardless of the arming

mode selected, and is independently programmable from 0 - 99 seconds (field

✱34).

This zone type is usually assigned to sensors or contacts on doors through

which primary entry and exit will take place.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 49

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56