Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 64)

–64–

ZN ZT P RC IN: L

10 03 1 3C RF: 1 s

The summary screen for the zone will appear. Note that an "s"

indicates that a serial number has, in fact, been enrolled. The cursor

will be flashing above the loop number. Press [

✱

] to accept the zone

information.

NOTE: If you entered “0” in the "LEARN S/N?" prompt previously,

you will not get an indication that the serial number has been

enrolled.

If you want to delete the serial number, enter "0" and press [

✱

]. The

system will then prompt, "DELETE S/N?" Press the "1" (YES) key to

complete the delete sequence. This process deletes the serial number

only, not the loop number. The assumption is that the proper loop

number was programmed, but the wrong serial or loop number was

enrolled. To change the loop number, you must go back through zone

programming for that zone and manually enter the loop number over

the existing one.

PROGRAM ALPHA?

0 = NO 1 = YES 0

E N T E R ZN NU M .

( 0 0 = Q U I T ) 1 1

If you want to program alpha descriptors now, enter "1" (YES). See

the ALPHA DESCRIPTOR PROGRAMMING section for more

information.

If not, enter "0" (NO).

This will return you to the ENTER ZN NUM. prompt for the next

zone. When all zones have been programmed, enter “00” to quit.

If you plan to enroll serial numbers in the sequential mode, enter “00”

to quit, then go to the SEQUENTIAL MODE section later in this

manual to enroll the serial numbers.

When you have finished programming all zones (including all serial numbers),

test each zone using the system's TEST mode. Do not use the Transmitter ID

Sniffer mode for this, as it will only check for transmission of one zone on a

particular transmitter, and NOT the zones assigned to each additional loop.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 103 104

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 64