Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 47)

–47–

Section 14. MECHANICS OF PROGRAMMING

This section provides information on how to use the system's programming

modes. It will enable you to understand how to enter and exit programming

mode, and how to program the data fields and how to use the user-friendly

interactive modes (

✱

56,

✱

80,

✱

81,

✱

82,

✱

83).

If RF zones or wired expansion will be used, the following program fields must

be programmed (as required) before doing any zone programming.

✱

22 RF SYSTEM

✱

25 WIRED ZONE EXPANSION

In addition, the following fields must be programmed before completing the installation.

✱

20 INSTALLER CODE

General Programming Information

Characteristics for each installation are stored in non-removable, electrically

erasable, non-volatile EEPROM memory. These must be programmed for the

particular installation to establish its specific alarm and reporting features.

It is possible to program the system at any time, even at the installer's

premises prior to the actual installation. Simply apply power temporarily to

the control and then program the unit as desired.

IMPORTANT:

You cannot enter the programming mode unless the

security system is disarmed.

There are two programming modes: data field programming and interactive

(menu) mode programming. Data field programming is used for setting

various system options and interactive programming is used for

programming zone information, programming relay outputs, and for enrolling

transmitter serial numbers.

To program the system, you must use a AM6139 2-line Alpha keypad

connected to the keypad terminals on the control (4, 5, 6, & 7). Also, the

security system must be disarmed. The Alpha keypad need not necessarily

remain in the system after programming.

Programming can also be performed remotely from the installer’s office/home,

using an IBM personal computer, a modem, and V-Link downloading

software. See the REMOTE PROGRAMMING AND CONTROL

(DOWNLOADING) section.

Entering Program Mode

You may use one of the following methods:

a) Press both the [

✱

] and [#] keys at the same time within 50 seconds after

power is applied to the Control, or

b) After power up, enter the Installer code (4 1 1 2) + 8 0 0.

This method is disabled if you exit the program mode using

✱

98 instead of

✱

99. See “Exiting Program Mode” paragraph later in this section.

If a different Installer code is subsequently programmed, use it instead of

4112 to gain access to the Programming mode.

Following entry into program mode, data field

✱

20 will be displayed (this is

the first data field in the system). The system will now accept entries for

field

✱

20.

Programming a Data Field

1. Press [

✱

] plus Field No. (for example,

✱

21), then make the required entry.

2. When you have completely programmed a data field, the keypad will

“beep” three times and then automatically display the next data field in

sequence. To go to a different field, press [

✱

] plus the desired field No.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 47

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56