Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 48)

–4

–

3. If the number of digits that you need to enter in a data field is less than

the maximum digits available (for example, the phone number field), enter

the desired data, then press [

✱]

and the next data field number to be

programmed.

4. If you try to enter a non-existent field, the keypad will display EE or

Entry Error. Simply re-enter [

✱

] plus a valid field number.

Reviewing a Data Field/Erasing an Entry in a Data Field

Press [#] plus Field No. Data will be displayed for that field number. No

changes will be accepted in this mode.

To delete an entry in a field, press [

✱

] plus Field No. + [

✱

]. (Applies only to

fields

✱

40–

✱

44,

✱

88, and

✱

94).

Interactive Mode Programming (

✱

56,

✱

80,

✱

81,

✱

82 and

✱

83)

Typical prompt

displayed during

interactive mode

programming

Enter Zn Num.

(00 = Quit) 01

Zone Number ↑

Press [

✱

] plus interactive mode no. (for example,

✱

56). The Alpha keypad

will display the first of a series of prompts requesting entries.

A detailed procedure (with displays of prompts) is provided in later sections

of this manual.

Interactive Mode Used To Program

✱

56 Zone Programming Zone characteristics, report codes, alpha

descriptors and serial numbers

✱

80 Relay Programming 4229 or 4204 Relay modules, or Powerline

Carrier devices

✱

81 Zone List Programming Zone Lists for relay/powerline carrier

activation

✱

82 Alpha Programming Zone alpha descriptors

✱

83 Sequential Mode 5800 series transmitter serial numbers

Loading Factory Defaults

To load the factory defaults, enter the programming mode, press

✱

97, then

exit the programming mode.

Do not press

✱

97 to load defaults if any programming has been done

previously—data already programmed into the system will be changed!

✱

96 resets all the Subscriber Account numbers and CSID in preparation for

an initial download.

Programming System Setup Fields

The following program fields must be programmed before doing any zone

programming.

✱

22 RF SYSTEM 0

Enter 1 if 5881/5882 RF receiver is being used; enter 0 if no receiver is

being used. Default is 0 (none).

✱

25 WIRED ZONE EXPANSION 0

Use this field to select the type of expansion unit being used, as follows:

0 = none; 1 = 4219; 2 = 4229; 3 = 4204. Default is 0.

Exiting the Programming Mode

✱

99 allows re-entry into the program mode using Installer Code + 8 0 0.

✱

98 inhibits re-entry into the programming mode using the Installer code.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 48

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56