Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 24)

–24–

Installation and Setup of the 5881/5882 Receiver

1 2 3 4

ON OFF

1. Set the receiver's DIP switch for device address “0”, as described in its instructions (all

switches to the right. . . “off”).

2. Mount the receiver. The RF receiver can detect signals from transmitters within a

nominal range of 200 feet. Take this into consideration when determining mounting

location.

3. Connect the receiver's wire harness to the control's keypad terminals (4, 5, 6, and 7).

Plug the connector at the other end of the harness into the receiver.

4. Refer to the installation instructions provided with the receiver for further installation

procedures regarding antenna mounting, etc.

MOUNTING

HOLES

INTERFERENCE

INDICATOR

LED

CIRCUIT

BOARD

DIP SWITCH

PLUG

SOCKET

INSERT IN

RIGHT-HAND

TERMINALS

ANTENNAS

YELLOW

RED

BLACK

GREEN

}

TO CONTROL’S

REMOTE KEYPAD

CONNECTION

POINTS.

WIRING

OPENING

KNOCKOUT

AREA FOR

SURFACE

WIRING

5882

LOCATION

}

TO RELEASE CIRCUIT BOARD,

REMOVE SCREWS (2)

AND BEND BACK TABS (2).

MODEL No. IS INDICATED

ON CIRCUIT BOARD

NOTE: CIRCUIT BOARD IS MOUNTED IN

CONTROL’S CABINET, GROUNDING LUGS (2)

PROVIDED

MUST

BE INSERTED IN LEFT-

HAND TERMINALS OF ANTENNA BLOCKS AND

SECURED TO CABINET (SEE RECEIVER’S

AND CONTROL’S INSTRUCTIONS)

Figure 12. 5881/5882 RF Receiver (cover removed)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 24

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56