Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 51)

–51–

Section 16. DATA FIELD DESCRIPTIONS

Descriptions of System Data Fields

THE BLANK PROGRAMMING FORM SHOULD BE USED TO RECORD THE DATA FOR THIS INSTALLATION

Defaults (where applicable) Are Indicated In Text

The following pages list all data fields used in this control (in numerical order). If you have

performed the programming instructions that were included with the installation of each of

the various peripheral devices covered in previous sections, this table will simply serve as a

reference for all data fields in the system. If you have decided to program all the data fields

in the system at one time (and therefore did not perform the programming indicated

previously in each section), you can use this listing to program all the data fields now.

✱

20 INSTALLER CODE 4 | 1 | 1 | 2

The Installer code is used to enter the 4-digit Master security code in

the normal operation mode, via the keypad. See "Master Code" in

the SYSTEM OPERATION section for procedure.

Enter 4 digits, 0–9.

✱

22 RF SYSTEM 0

0 = no RF receiver being used

1 = 5881/5882 RF receiver being used

✱

23 FORCED BYPASS FUNCTION 0

0 = no forced bypass

1 = provide automatic bypass of all open (faulted) zones

All zones bypassed by this function will be displayed after the bypass

is initiated.

UL installations: must be 0 (no forced bypass)

✱

24 RF HOUSE ID CODE 0 | 0

00 = disable all wireless keypad usage

01-31 = House ID

The House ID identifies receivers and wireless keypads.

If a 5827 or 5827BD Wireless keypad or 5804BD transmitter is to be

used, a House ID code MUST be entered, and the wireless keypad

should be set to the same ID.

✱

25 WIRED ZONE EXPANSION 0

0 = no expander module connected

1 = 4219 connected

2 = 4229 connected

3 = 4204 connected

✱

26 CHIME BY ZONE 0

0 = no (chimes on fault of any entry/exit or perimeter zone when

chime mode activated)

1 = yes (chimes on fault of specific zones programmed in relay zone

list 3 when chime mode activated)

This option allows the installer to define the specific zones intended

to chime when faulted while the system is in chime mode.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 51

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56