Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 85)

–85–

SUMMARY OF ARMING MODES

Features for Each Arming Mode

Arming

Mode

Exit

Delay

Entry

Delay

Perimeter

Armed

Interior

Armed

AWAY Yes Yes Yes Yes

HOME Yes Yes Yes No

INSTANT Yes No Yes No

*MAXIMUM Yes No Yes Yes

Panic Keys

*This feature is not advertised in order to prevent false alarms by the user

while at home with ALL protected zones (interior and exterior) armed.

There are three panic key pairs that can be used to manually initiate alarms

and send a report to the central station.

Each can be individually programmed for 24-hour Silent, Audible, Personal or

Fire Emergency responses. The panic function is activated when both keys of

the appropriate key pair are pressed at the same time.

The panic functions are identified by the system as follows:

Keys Displayed as Zone

[1] & [

✱

]95

[

✱

] & [#] 99

[3] & [#] 96

Important: For the Silent Panic functions to be of practical value, the

system must be connected to a central station.

Relay/Powerline Carrier

Devices

(if used)

If relay outputs (via a 4204, or 4229), or Powerline Carrier devices are used,

two keypad entries available to the user are included. They can manually

activate or deactivate the device(s) for starting or stopping some action, such

as turning lights on or off, etc.

These keypad entries are:

Security Code + [#] + [7] + Device # activates (starts) that device.

Security Code + [#] + [8] + Device # de-activates (stops) that device.

4285/4286 Phone Module

(if used)

Refer to the separate instructions supplied with the Phone Module for

information concerning its operating procedures.

Note: The Phone Module cannot be used to add user codes in this system.

User codes must be added by using a wired keypad.

Exit Error Alarm

Displays

(if programmed)

• A display of "CANCEL ALARM" or "CA" and a zone indication will

appear if an exit or interior zone contained a fault during closing at the

time the exit delay ended (e.g., exit door left open), but the system was

disarmed during the entry delay time. The alarm sounder and keypad

sound continuously, but stop when the system is disarmed. No message

will be transmitted to the central station.

• A display of "EXIT ALARM" or "EA" and a zone indication will

appear if an exit or interior zone contained a fault during closing at the

time the exit delay ended, but the system was NOT disarmed during

the entry delay time. The alarm sounder and keypad sound

continuously until the system is disarmed (or timeout occurs). An "exit

alarm" message is sent to the central station.

• The "EXIT ALARM" display, etc. will also result if an alarm from an

exit or interior zone occurs within two minutes after the end of an exit

delay.

In any of the above cases, use a second OFF sequence (code plus OFF key) to

clear the display.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 85

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56