Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 88)

–88–

• When one button of a transmitter (RF, UR, or BR) is activated, all

zones assigned to other buttons on that transmitter are cleared. This

also applies to 5816 and 5817 transmitters which have multiple loops

(zones).

• Any transmitter that is not “enrolled” will not turn off its zone

number.

Exit this mode by keying Installer code + OFF.

b. GO/NO GO TEST MODE: By pressing Installer code + # + 4 on

keypad, a mode similar to the user test mode (code + TEST) is entered,

but the wireless receiver gain is reduced. Checking in this mode assists

in determining good mounting locations for the transmitters when the

system is being installed and verifies that the RF transmission has

sufficient signal amplitude margin for the installed system.

Exit the mode by entering Installer code + OFF.

NOTE: System Test Mode (code + test) will be automatically terminated

in approximately 4 hours if the installer or user does not manually

terminate it.

This insures that Fire and Panic zones will not remain disabled.

However, Sniffer Mode (installer code + # + 3) does not automatically

expire. You must manually exit (installer code + OFF) sniffer mode to

return to normal operation. Sniffer Mode also terminates if a user arms the

system.

TO THE INSTALLER

Regular maintenance and inspection (at least annually) by the installer and frequent testing by

the user are vital to continuous satisfactory operation of any alarm system.

The installer should assume the responsibility of developing and offering a regular maintenance

program to the user as well as acquainting the user with the proper operation and limitations of

the alarm system and its component parts. Recommendations must be included for a specific

program of frequent testing (at least weekly) to insure the system's proper operation at all times.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 103 104

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 88