Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 35)

–35–

Programming the 4285/4286 Phone Module

The system must be programmed for use with the 4285 or 4286 Phone

Module, including assigning a phone code and selecting words from the alpha

vocabulary. Refer to the Programming sections for specific programming

details.

Checking the Operation of the 4285/4286 Phone Module

To Check Phone Module Operation From an On-Premises Phone:

1. Pick up phone and enter the programmed 2-digit phone code.

Annunciation of a system status report should automatically start. See

the User’s Guide accompanying the Phone Module for detailed information

regarding the nature of the status report, if necessary.

2. During any pause in the status report, or immediately following it, key the

following via the keypad on the phone:

Installer Code, then press key 1 (OFF).

3. A ”beep” should be heard on the phone and from a wired keypad, and the

words SYSTEM READY or NOT READY-Press ✱ to show faults*

should be heard, indicating that the command was entered successfully.

* NOT READY-Press ✱ to show faults would indicate an open zone.

4. Hang up the phone.

To Check Phone Module Operation From an Off-Premises Phone:

1. Have someone dial the premises phone number, using a TouchTone

phone.

• If the phone system does not include an answering machine, 2 long

tones will be heard in the caller’s phone, followed by a voice prompt

"HELLO, ENTER PHONE CODE NOW." The caller should enter

the programmed 2-digit phone code.

• If the premises phone system includes an answering machine, the 2-

digit phone code should be entered during a pause at the beginning of,

or during, the outgoing answering machine message.

2. When the 2-digit phone code is entered, the caller will hear a voice

prompt asking for entry of the 4-digit system code ("ENTER SYSTEM

CODE NOW").

3. The caller should then enter the installer code or any valid user code. As

a safety feature, there is a 3-try limit in which to enter each code (phone

code and system code), after which time the call-in will be aborted. Also,

if no keys are pressed for a period of 20 seconds, the call-in will be

aborted.

4. Annunciation of a system status report will start if both codes were

entered correctly.

5 During any pause in the status report, or immediately following it, the

caller should key the following via the keypad on the phone:

Installer Code, then 1 (OFF).

6. A ”beep” should be heard (and from a wired keypad on the premises), and

the words SYSTEM READY or NOT READY-Press ✱ to show faults*

should be heard on the caller’s phone, indicating that the command was

entered successfully.

* NOT READY-Press ✱ to show faults would indicate an open zone.

7. At this point, the caller can hang up the phone.

8. Verify with the caller that there was successful access to the system and

that the appropriate annunciations were heard over the phone.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 35

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56