Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 83)

–83–

Section 24. SYSTEM OPERATION

Security Codes

Installer Code

The installer programs the 4-digit Installer Code initially as part of the

programming procedure. The factory default Installer code is "4-1-1-2", but

may be changed in field

✱

20.

The Installer code is the only code that can enter programming mode and

also, in normal operation mode, is used to enter the Master code which allows

access to the normal functions of the system.

Master Code

In normal operation mode, the Installer code is used to enter the 4-digit

System Master security code using the connected keypad. Therefore:

To enter the System's Master code , enter:

Installer Code + [8] + [02] + desired 4-digit Master code.

To change the Master code, enter:

Current Master code + [8] + [02] + new Master code + new Master code

again

Secondary User Codes

In normal operation mode, the system’s Master security code can be used

to assign up to 12 secondary 4-digit security codes plus a babysitter code and

a duress code. The master code can also be used to remove secondary codes

from the system (individually).

To assign (or change) a Secondary security code, enter (via the systems

keypad):

System's Master Code + [CODE key] + User # (03–16) +

desired Secondary Code

The system will emit a single beep when each secondary code has been

successfully entered.

To delete a Secondary security code, enter (via the system's keypad):

System's Master Code + [CODE key] + User # (03–16)

Notes: • The Master code and all Secondary security codes permit access to the

system for arming, disarming, etc.

• The installer code can disarm the system only if it was used to arm it.

• Babysitter code is User code No. 15; it can disarm the system only if that

code (or the installer code) was used to arm it.

• Duress code is User code No. 16. When this is used to perform any system

operation, a special code is sent to the monitoring station. Instruct users

to be careful not to use this code for normal usage.

• If a secondary code is inadvertently repeated for different users, the lower

user number will take priority.

• Opening and closing reports are sent for the Installer code as No. 01, with

the appropriate subscriber number. The Master code and secondary user

codes are sent as Nos. 02, and 03–16 respectively in Contact ID format

(with the appropriate subscriber number); in 4+2, it is 1–F, “F” for

anything greater than 14.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 83

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56