Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 71)

–71–

Summary Mode Display

Default Descriptor ▼

✳ ZN 0 1 Z O N E 0 1

If a descriptor was not entered

previously for zone 1, the default

descriptor for zone 1 will be

displayed.

Note that this a “summary mode”,

and that no entries can be made.

Entries can be made only when the

display contains a flashing cursor,

which signifies the “entry mode."

Flashing Cursor (system is

ready for entry of word).

▼

✳ ZN 0 1

5. To delete or change the default

descriptor for zone 1, press

✱

plus

the same zone number (01). This

will clear that descriptor and allow

changes to be made at the flashing

cursor.

NOTE: If you do not wish to change

the existing descriptor for zone 1,

enter [

✱

] plus the next zone number

for which you wish to enter (or check)

a descriptor. A summary display for

that zone will appear. You must then

press [

✱

] plus the same zone number

again to gain access to the entry

mode (flashing cursor) for that zone.

Flashing Cursor

▼

✳ ZN 0 1 B A C K

✳ ZN 0 1 B A C K

▲

Flashing Cursor if “6” is

pressed

(system is ready

for next word).

6. Press [#] plus 3-digit number for

the first word from the “Alpha

Vocabulary List." Example: The

descriptor that we wish to enter for

zone 1 is BACK DOOR

.

From the

list, BACK = 013. Therefore, you

would enter # 0 1 3.

Note: If you accidentally enter the

wrong word, simply press [#] plus the

correct 3-digit number for the word

you want.

7. Press “6” to accept the selected

word and continue.

NOTE: If this is the only word you

are using for the descriptor, press “8”

instead of “6” to save that word in

memory, and then go to step 11.

Z N 0 1 B A C K

D O O R

▲Flashing Cursor

8. Enter the 3-digit number for the

next word. In our example, the

word is DOOR, whose number is

“057."

Enter # 0 5 7. This display will

appear:

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 103 104

Komentáře k této Příručce

Žádné komentáře