Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 53)

–53–

✱

33 ALARM BELL TIMEOUT 1

0 = No timeout

1 = 4 min

2 = 8 min

3 = 12 min

4 = 16 min

This field determines whether the external sounder will shut off after

time allotted, or continue until manually turned off.

UL installations: must be set for a minimum of 4 min (option 1)

NOTE: If the fire sounder of

✱

32 is programmed for no timeout with

✱

33 programmed for 4 to 16 minutes of alarm bell ringing, and a

burglary alarm is triggered at the same time a fire is detected, the

alarm bell will timeout as specified in

✱

33.

✱

34 EXIT DELAY 9 | 9

00 - 99 = exit delay time in seconds

The system will wait the time entered before sounding an alarm if the

exit door is left opened after the system has been armed.

✱

35 ENTRY DELAY 1 6| 0

00 - 99 = entry delay time in secs.

The system will wait the time entered before sounding alarm upon

entering.

UL installations: must be set for a maximum of 20 seconds

✱

36 ENTRY DELAY 2 9| 0

00 - 99 = entry delay time in secs.

The system will wait the time entered before sounding alarm upon

entering.

UL installations: must be set for a maximum of 20 seconds

✱

37 AUDIBLE EXIT WARNING 1

0 = no exit warning sound

1 = provide exit warning sound when armed AWAY

Warning sound consists of slow continuous beeps until last 5 seconds,

when it changes to fast beeps. The warning sound will end at the

termination of Exit time.

✱

38 CONFIRMATION OF ARMING DING 0

0 = no ding

1 = confirmation ding after arming system

2 = confirmation ding after arming from RF button or RF keypad only

(ding occurs when the system receives the RF transmission.)

Confirmation of arming is 1/2 second external sounder “ding” when

closing report is sent, or at the end of exit delay.

✱

39 POWER UP IN PREVIOUS STATE 1

0 = always power up in a disarmed state

1 = assume the system status prior to power down

When the system powers up armed, an alarm will occur 1 minute after

arming if a zone is faulted.

Note that if the previous state was armed AWAY or HOME, the

system will not respond to sensor changes for 1 minute, which allows

time for sensors such as PIRs to stabilize. This means that if a zone

faults during that 1 minute time period, the system will not detect the

faulting and would power up into the armed ON AWAY or ON HOME

original state.

UL installations: must be 1 (power up in previous state)

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 53

Komentáře k této Příručce

Související produkty a manuály pro Sítě Datacom Systems D56