Datacom Systems D56 Průvodce řešením problémů stáhnout pdf (Strana 77)

–77–

10 CONFIRMED

A022-4064 3

When the system sees activity on the appropriate input, it will beep

three times and display the confirmation message. Press [

✱

] or the

upper left-hand button of the program tool when you are ready to

enroll the next transmitter.

At any time during this step, you may press the [✱] key on the keypad or the

upper left-hand button of the program tool if you are satisfied with the serial and

loop number combination that has been enrolled, regardless of whether or not

the enrolled input has been "confirmed." This will ready the system to enroll the

next transmitter.

If the incorrect transmitter has been enrolled, press the [#] key on the keypad or

the upper right-hand button of the program tool to delete the serial number and

return to the "LEARN S/N" prompt. A single long beep will be heard from the

keypad to verify pressing of the upper right-hand button. Then, press "1" (Yes)

or press the upper left-hand button of the program tool (a single short beep will

verify the system is ready for enrolling) and re-activate the proper transmitter or

transmitter loop input.

7. The system will search for the next zone that does not have a serial

number associated with it. If one is found, the prompt in step 5,

along with the appropriate zone number, will be displayed. Follow

steps 5 and 6 for the remaining wireless zones.

When the last zone has been enrolled, the display will remain on that

zone. To exit this mode and return to data field program mode, press [✱].

When you have finished programming all zones, test each using the system's

TEST mode. Do not use the Transmitter ID Sniffer mode for this, as it will only

check for transmission of one zone on a particular transmitter, and NOT the

zones assigned to each additional loop.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 103 104

Žádné komentáře

Datacom Systems D56 Průvodce řešením problémů Strana 77